Over the last month work has continued on the conservation workshop building, the roof is being installed and will be finished in copper next month. A retaining wall behind the building has also been constructed which will later form a timber store for planks used in the boat conservation.
The concrete foundation for the café was completed and the steel structure for this building has been erected. The structure beautifully frames the views towards the Langdales and across to Claife Heights which future visitors will be able to enjoy over cake and a cup of coffee.
On Friday 10 June, Turner & Townsend staff from offices around the country took part in a 92-mile cycle ride from Newcastle, where our project and cost management team are based, to the Windermere Jetty site to raise funds in support of the project.
Eleven riders set off from the Newcastle office near to the Tyne bridge at 7am on Friday morning. The route took them across the Pennines climbing over 9000 feet over Rookhope, Allenheads, Hartside and Kirkstone Pass. They all successfully completed the ride arriving at the museum site eight and half hours later.
The first buildings have begun to emerge from the ground at the museum site on Windermere. The steel structure for the new conservation workshop was erected last month, although it is still to be clad the building already frames stunning views across the lake as can be seen in the photo above. The new boathouse structure has also begun to take shape spanning the water where boats will later be moored and visitors will see them bobbing on the lake. Groundworks have also continued preparing the site for the café building and learning centre that are next on the list to erect.
Whilst there is still lots of work to be done in the ground for all of the new museum buildings, this month has seen the beginnings of a building emerge from the dusty site. Following on from the foundations completed last month, the concrete slab forming the base of the whole conservation workshop building has been created. Timber shuttering was built around the perimeter of the building, this was followed by reinforcing mesh before concrete was poured into the template. Once cured, the shuttering was removed to reveal the building’s footprint.
Work in the ground is well underway for the new workshop building. This area has undergone dewatering to enable the contractors to dig below the water table to install drainage and foundations. The process involved inserting a series of well points around the whole area, these were then attached to pumps which extract and filter the water.